10A-PPS

Model：10A-PPS
Description：

The BeamTrack series 10A-PPS laser measurement sensor measures laser beam size and position well as power and energy. It has a 16mm aperture and can measure beam size to 5% accuracy and position to 0.1mm accuracy. It measures power from 20mW to 10W and energy from 6mJ to 2J.

Price(USD)：$0

Content

Model Use	10A-PPS ^(a) Low power
Functions	Power / Energy / Position / Size
Absorber Type	Broadband
Spectral Range	0.19 - 20µm
Aperture	Ø16mm
Power Mode
Power Range	20mW - 10W
Power Scales	10W / 5W / 0.5W
Power Noise Level	1mW
Thermal Drift (30min)%	NA
Maximum Average Power Density	28kW/cm²
Response Time with Meter (0-95%) typ.	0.8s
Calibration Uncertainty	±1.9%
Power Accuracy ^(g)	±3%
Linearity with Power	±1%
Energy Mode
Energy Range	6mJ - 2J
Energy Scales	2J / 200mJ
Minimum Energy	6mJ
Maximum Energy Density J/cm²
<100ns	0.3
0.5ms	2
2ms	2
10ms	2
Beam Tracking Mode
Position
Beam Position Accuracy^(c)	0.15mm
Beam Position Resolution	0.02mm
Min Power for Position Measurement	50mW
Size ^(d)
Size Accuracy mm (e)	±(5%+50µm) for centered beam
Size Range (4σ beam diameter)	1.5 - 10mm
Min Power for Size Measurement	50mW
Cooling	convection
Weight	0.3
Fiber Adapter Available	ST, FC, SMA, SC
Part number	7Z07904
Notes: (a) The BeamTrack features are supported by Centauri, StarBright, StarLite, Nova II and Vega meters, Juno, Juno+ and EA-1 interfaces and StarLab application. Position and Size measurements work only in Power mode (but not in single shot Energy mode). (b) Depending on room airflow and temperature variations. (c) For position within inner 30% of aperture. Position measuring center corresponds to geometrical center within <1mm. Position center can be software reset to geometric center or other desired position with Centauri, StarBright or StarLab. (d) Assumes laser beam with circular Gaussian (TEM00) distribution. For other modes, size measurement is relative. (e) Accuracy spec will be maintained for beams ≥1.8 mm not deviating from center by more than 15% of beam diameter. (f) For P type and shorter wavelengths derate maximum energy density as follows: Wavelength Derate to value 1064nm Not derated 532nm Not derated 355nm 40% of stated value 266nm 10% of stated valuee 193nm 10% of stated value (g) The 3A-QUAD has a relatively large spectral variation in absorption and has a calibrated spectral curve at all wavelengths in its spectral range to the above specified accuracy. Nova, Orion and LaserStar meters do not support this feature and when used with those meters, the accuracy will be ±3% as above for 532nm, 905nm, 1064nm and 10.6μm but there will be an additional error of up to 3% at other wavelengths in the spectral range 190 – 3000nm.