| Absorber Type |
LP2 |
| Spectral Range |
0.35-2.2µm |
| Absorption |
>94% from 0.35 to 1.1μm |
| Aperture |
Ø34mm |
| Power Mode |
| Power Range |
5W - 1000W |
| Power Scales |
1000W / 200W |
| Power Noise Level |
200mW |
| Maximum Average Power Density |
12kW/cm2 at 500W
10kW/cm2 at 1000W |
| Response Time with Meter (0-95%) typ. |
2.5 s |
| Calibration Uncertainty |
±1.9% |
| Power Accuracy |
±3% (a) |
| Linearity with Power |
±2% |
| Energy Mode |
| Energy Range |
400mJ - 300J |
| Energy Scales |
300J / 30J |
| Minimum Energy |
400mJ |
| Maximum Energy Density J/cm2 |
|
| <100ns |
0.1 |
| 1µs |
0.9 |
| 0.5ms |
50 |
| 2ms |
130 |
| 10ms |
400 |
| Cooling |
water |
| Minimum and Recommended water flow at full power (b) |
3 liter/min 6 liter/min |
| Fiber Adapters |
Consult Ophir representative |
| Weight |
0.8 |
| Part number: Standard Sensor |
7Z02774 |
Notes:
(a) For spectral range 0.35 to 1.1μm
(b) Water temperature range 18-30°C. Water temperature rate of change <1°C/min. Pressure drop across sensor 0.03MPa. The recommended flow rate can be lowered proportionately at lower than full power but should not be below the minimum. When used at full power with substantially below the recommended flow rate, the damage threshold may be as much as 20% lower. The response time will be optimum with the recommended flow rate.
(c) The 1000WP-BB-34 has a nylon rear housing and nothing but nylon and copper in contact with the water flow. This prevents contamination of the water flow with aluminum and prevents the possibility of corrosion. |
A-PF-120_1000x680.jpg)
